PVT

PVT is acronym for Process-Voltage-Temperature.

PVTs model variations in Process, Voltage and Temperature. There's other term OCV which refers to On-Chip Variation. PVTs model inter-chip variations while OCVs model intra-chip variations.


We'll talk about OCVs in some other post.
Let's talk about PVTs in detail:

1) Process:

You must have heard people talking in terms of process values like 90nm, 65nm, 45nm and other technology nodes. These values are characteristic of any technology and represents the length between the Source and Drain of a MOS transistor that you might have studied in your under-grad courses. While manufacturing any die, it has been seen that the dies that are present at the center are pretty accurate in their process values. But the ones lying on the periphery tend to deviate from this process value. The deviation is not big, but can have significant impact on timing.


Recall from your undergrad courses the following formula for current flowing in a MOS transistor:

 L represents the process value. For same temperature and voltage values, current for 45nm process would be more than current for 65nm process.
More is the current, faster is the charging/discharging of capacitors. And this means, delays are less.

2) Voltage:

The voltage that any semiconductor chip works upon is given from outside. Recall while working on breadboards in your labs, you used to connect a 5V supply to the Vcc pin of your IC. Modern chips work on very less voltage than that. Typically around 1V-1.2V.


This voltage must be the output of either a DC source or maybe the output of some voltage regulator. The output voltage of voltage regulator might not be a constant over a period of time. Let's say, you expected your voltage regulator to give 1.2V, but after 4 years, it's voltage dropped down to 1.08V or increased up to 1.32V. So, you gotta make sure your chip is working well between 1.08 and 1.32V!!


This is where the need to model Voltage variations come into picture.
From the same equation as above, it can be seen that more is the voltage, more is the current. And hence, delays are less.

3) Temperature:

The ambient temperature also impacts the timing. Let's say you are working on a gadget in Siachen glacier where temperature can drop down to -40 degrees centigrade in winters and you expect your device to be working fine. Or maybe you are in Sahara desert, where ambient temperature is +50 degrees and your car engine temperature is +150 degrees and again you expect your chip to working fine. While designing, therefore, STA engineers need to make sure that their chip will function correctly in the temperatures between -40 to +150 degrees.



Higher is the temperature, more is the collision rate of electrons within the device. This increased collision rate forbids other electrons in the periphery to move. Since electron movement is responsible for current flowing in the device, current would decrease with increase in temperature. Therefore, delays are normally more at higher temperatures.


For technology nodes below 65nm, there's a phenomenon called TEMPERATURE INVERSION, where delays tend to increase with decreasing temperature. We shall talk about the same later. Don't get confused with it here.

WORST PVT:

Process worst-Voltage min- Temperature-max

BEST PVT:

Process best-Voltage max- Temperature-min

WORST COLD PVT:

Process worst-Voltage min-Temperature min

BEST HOT:

Process best-Voltage max-Temperature max